Grinder Pumps
A grinder pump is a wastewater conveyance device. ... Once the wastewater inside the tank reaches a specific level, the pump will turn on, grind the waste into a fine slurry, and pump it to the central sewer system or septic tank. Grinder pumps can be installed in the basement or in the yard.The Upgrade from E/One is a replacement grinder pump engineered to fit into virtually any grinder pump wet well. Universal design allows easy drop-in conversion, ready to connect. The Upgrade is a complete replacement for all of the troublesome components of a centrifugal pump, including slide rails, pump/motor, float switches, piping and motor control devices. "E/One Grinder"
E/One Grinder
- All solids are ground into fine particles, allowing them to pass easily through the pump.
- The grinder is designed not to jam and for minimum wear to the grinding mechanism.
- The 1 1/4" slide face discharge connection is adaptable to any existing discharge piping.
- Grinder pump is automatically activated and runs for very short periods.
- Units are available with a number of discharge hose lengths to accommodate a wide range of existing tank depths.
- 1 HP, 1725 rpm, high torque, capacitor start, thermally protected, 240 or 120 volt, 60 hertz, 1 phase
- This model was previously known as the AMGP.
- E/One PDF Performance.
D-Series | DH071 & DR071 Grinder Pump Station.
- DH071
- DR071
- The E/One model DH071/DR071 simplex grinder pump station is an ideal choice for single-family homes.
- Grinder pumps pump wastewater from the home to the central sewer and/or treatment system through small-diameter pipes.
- The DH071 is the “hardwired,” or “wired,” model where a cable connects the motor controls to the level controls through watertight penetrations.
- The DR071 is the “radio frequency identification” (RFID), or “wireless,” model that uses wireless technology to communicate between the level controls and the motor controls.
- The tank is made from tough, corrosion-resistant HDPE and offers 70 gallons of capacity.
- pump core can be quickly pulled out and replaced, meaning minimal maintenance costs and inconvenience for the homeowner.
- Units are available for indoor and outdoor installations. Outdoor units accommodate a wide range of depths.
- Motor: 1 HP, 1725 rpm, high torque, capacitor start, thermally protected, 240 or 120 volt, 60 hertz, 1 phase.
- DH071 & DR071 Install PDF.